Page 1 of 1

Stickers

PostPosted: Sat Jan 03, 2015 8:47 pm
by White Oak 06
This question is about cases , new brass.
What all do you do with new brass as far as preparation, trim to length , chamfer and what else ?

Thanks !
,

Re: Stickers

PostPosted: Sat Jan 03, 2015 8:53 pm
by stickers
I always trim and chamfer and of course prime new cases. I try to trim to about .001-.003 short of recommended case length. But that is just so I dont have to trim so much after it is fired for the first time.

Re: Stickers

PostPosted: Sat Jan 03, 2015 9:02 pm
by White Oak 06
No full length size , and does that neck size it too ( FL sizing )

Can you use any brand case for any reloading manual ?

What kind of groups are you getting ?

Re: Stickers

PostPosted: Sun Jan 04, 2015 6:32 am
by stickers
White Oak 06 wrote:No full length size , and does that neck size it too ( FL sizing )

Can you use any brand case for any reloading manual ?

What kind of groups are you getting ?



No I do not resize new cases. I can get sub moa on new cases . Yes , you can use any case. It is just personal preference as to caliber.

Re: Stickers

PostPosted: Sun Jan 04, 2015 9:26 am
by White Oak 06
Thanks stickers !
So no problems with bolt extraction?

When reading up on this stuff, I'm reading about different case capacities and thickness of the 3006 cases and people turning the necks !

Reloading manuals test their loads in a certain case , so can other cases be used and do they affect charge weights as far as different capacities like these people are talking about ?

Are these people over doing it ?